Home All Services Commercial Air Conditioning Air Conditioning Heat Pump Servicing Unvented Cylinders Water Treatment Plumbing Advice & Guides Case Studies About Contact Call 07717 846247
ac_unitF-Gas Qualified · Sevenoaks

Air Conditioning Installation in Sevenoaks

Home and commercial air conditioning supplied and fully installed across Sevenoaks, Riverhead, Otford, Kemsing and Seal. Single-split from £1,900 with no VAT, quoted in writing after a free survey.

verified_userF-Gas Qualified
handymanPeriod Property Experience
money_offNo VAT to Add

paymentsSevenoaks Pricing

  • check_circleFrom £1,900 single-split, fully installed
  • check_circleFrom £3,500 multi-room systems
  • check_circleFree survey & fixed written quote
  • check_circleConservation area & AONB advice
  • check_circleExisting AC serviced from £120
placeAcross Sevenoaks

Air Conditioning for Sevenoaks Homes

Sevenoaks presents a particular set of challenges for air conditioning, and they are mostly to do with the buildings. Large period properties in and around the town with high ceilings and single glazing. Village housing in Otford, Kemsing and Seal, often older, often with restrictions. And a good number of substantial family homes where one south-facing bedroom or a converted loft becomes unusable in summer.

Pipe routing is the whole job

In a modern house, back-to-back and done. In a period property the pipe run is the difference between a tidy installation and a visible mess. Working out that route properly — and how it will be sealed and made good — is what the free survey is actually for.

Conservation areas, listed buildings and AONB

Parts of Sevenoaks district sit within conservation areas, the Kent Downs AONB, or involve listed properties where outdoor unit siting needs real care. Better to establish that at survey than on installation day.

Converted lofts and south-facing bedrooms

The most common Sevenoaks enquiry. A loft conversion with rooflights becomes an oven in July, and a single-split solves it properly for around £1,900 rather than a whole-house solution nobody needs.

It heats too, which matters in a big house

Reverse-cycle units heat efficiently in winter. In a large, older Sevenoaks property, heating one room with air conditioning is often much cheaper than bringing the whole heating system up for one cold room.

helpFAQ

Sevenoaks Air Conditioning Questions

Yes — across TN13, TN14 and TN15 including Riverhead, Dunton Green, Otford, Kemsing, Seal and Halstead. F-Gas qualified, with every installation quoted in writing after a free survey.
A single-split system, supplied and fully installed, starts from £1,900 with no VAT. Multi-room systems start from £3,500 and are quoted individually because pipe routing through a period property is a very different job to a modern one.
Whether an installation needs planning permission depends on the property, its use, where the outdoor unit is sited, the applicable standards and any local restrictions such as conservation areas or listed status. Many straightforward domestic single-split installations fall under permitted development, but that is not automatic. I check the position for your specific address at survey, and refer uncertain cases to the local authority. Sevenoaks has conservation areas and a number of listed properties where the rules are considerably tighter, and parts of the district sit within the Kent Downs AONB. I check the position for your specific property at survey.
Yes, and it is most of what I do around Sevenoaks. Pipe routing is the whole job in an older house — getting the run right so it is discreet, properly sealed and made good. That is exactly what the free survey is for.
Yes. A modern unit is a reverse-cycle heat pump, so it heats efficiently in winter as well as cooling in summer. In a large Sevenoaks house, heating one room with AC is often far cheaper than firing the whole system.
I do, with the manufacturer on completion using the commissioning details, so your cover is registered from day one, subject to the manufacturer's terms.
Usually. Tell me the make and model and I will tell you honestly whether matching or replacing makes better sense.
Some drilling dust, which I sheet for and clear. Boots off indoors. Making good around the pipe entry is part of the job, not an extra.
Modern indoor units are very quiet. The outdoor unit has a fan, so siting matters — away from bedroom windows and considerate to neighbours.

Book Your Free Sevenoaks Survey

From £1,900 fully installed, no VAT, across Sevenoaks, Riverhead, Otford, Kemsing and Seal.

call07717 846247
The Survey

How the Survey Works

The survey is the job. Get it right and installation is straightforward; skip it and you get the surprises that give the trade a bad name.

Where the indoor unit goes

Good airflow across the room, not blowing at a bed or sofa, reachable by pipework, and somewhere you are happy looking at.

Electrical supply

Where the power comes from and whether the existing arrangement suits. Established at survey, not on installation day.

What it will actually cost to run

Worth knowing before you buy rather than after. I will give you a realistic figure for the unit and the room rather than a brochure number.

The pipe route

Easy in a modern house. In an older property it is the whole job, and a discreet, properly sealed route is what separates a tidy install from a visible mess.

Where the outdoor unit goes

Airflow clearance, servicing access, noise for you and neighbours, mounting surface, and distance from the indoor unit — pipe run length affects performance.

What the Price Covers

What a Standard Installation Includes

The £1,900 starting price is a “from” price for a standard single-split installation. That means: one indoor wall unit and its matched outdoor unit, a back-to-back or short pipe run, the outdoor unit ground-mounted or on standard wall brackets at accessible height, connection to an existing suitable power supply, condensate drainage, and sealing and making good around the pipe entry.

What changes the price: longer or more complex pipe runs, working at height or where access equipment is needed, flat-roof or bracket mounting above normal reach, electrical supply work beyond a straightforward connection, difficult wall construction, and multiple rooms.

Electrical work. Connection to an existing suitable supply is included. If a new circuit, consumer unit work or certification is needed, that is identified at survey and quoted separately.

Warranty. I register your manufacturer warranty on completion using the commissioning details. Warranty eligibility depends on the manufacturer’s own terms, which normally require documented annual servicing. My own workmanship guarantee is 12 months, stated in writing on your invoice.